Owner`s manual

- 34 -
4) Bundle the excess lengths of the wires and fix them
to the instrument panel harness using the tie-wraps
⑦.
5) Disconnect the 3-pin connector of the instrument
panel harness from the junction block. Draw out the
No. 3 terminal from the connector and install the
terminal with red/green wire of the harness ③ to
that cavity. Reconnect the connector to the junction
block.
6) Disconnect the connector half on the 1-pin connector
(male) of the harness ③. Install the terminal drawn
out in step 4) to that connector half and reconnect it
to its original position.
7) Wrap the urethane tape C ④ around the 1-pin
connector to prevent rattling.
8) Fix the 1-pin connector harness as shown in the
drawing using the tie-wraps ⑦.
Check