Owner`s manual

- 33 -
G. ROUTING THE HARNESS AROUND
THE ETACS-ECU
1) Connect the 1-pin connector (female) of the harness
③ to the 1-pin connector of the front harness taped
with the black tape on the front harness at the front of
the ETACS-ECU.
2) Route the three quick splice connectors and the
terminal with red/green wire of the harness ③
along the instrument panel harness toward the
ETACS-ECU. Bundle the excess lengths of the
wires and fix them to the vehicle harness using the
tie-wraps ⑦.
3) Connect the three quick splice connectors of the
harness ③ to the wires from the gray and white
24-pin connectors connected to the ETACS-ECU
as follows.
The connector drawings show the positions of the
terminals as seen from the front (arrow direction)
of the connector.
Note