Owner`s manual

- 32 -
F. INSTALLING THE ELECTRONIC
CONTROL UNIT
1) Apply the two pieces of double-sided adhesive tape
⑥ and the urethane sheet B ④ on the electronic
control unit ① as shown in the drawing.
2) Wipe clean and degrease the installation position
of the electronic control unit ① at the deck
crossmember stay above the steering shaft using
isopropyl alcohol or degreaser.
3) Connect the 13-pin connector and the 12-pin
connector of the harness ③ to the electronic control
unit ①. Then peel off the backing strips of the
double-sided adhesive tape ⑥ and attach the
electronic control unit ① to the deck crossmember
stay above the steering shaft.
4) Route the harness ③ along the instrument panel
harness and fix the harnesses near the electronic
control unit ① using the tie-wraps ⑦.
5) Bundle the excess lengths of the wires to the
ground terminal and to the quick splice connector
(with white/black wire) and fix them properly on the
instrument panel harness using the tie-wrap ⑦.
6) Connect the antenna jack of the antenna unit ②
to the electronic control unit ①.
7) Secure the electronic control unit ① and also the
cable of the antenna unit ② on the deck
crossmember stay using the tie-wraps ⑦.
8) Bundle the excess length of the antenna unit cable
and fix it to the front harness using the tie-wrap ⑦.
- Perform this work in a well-ventilated space.
- Never use organic solvent such as thinner, benzine,
gasoline, etc.
Caution
!
Be sure not to touch the adhesive surface of the
adhesive tape by a dirty hand or glove or remove
and reapply the adhesive tape. Doing so makes
the tape lose much of its adhesion.
Caution
!
Check
Route the cable of the antenna unit ② so that it
does not interfere with the steering shaft.
Caution
!