Owner`s manual

- 3 -
- Be sure to disconnect the
negative terminal cable from
the battery.
- Loosen or tighten bolts and
nuts using tools that match their
sizes.
- Use a Phillips screwdriver that
fits the recess in the head of the
screw being loosened or
tightened.
- To remove plastic parts, use a
trim remover.
- When disconnecting connectors,
first unlock them, then separate
the connectors by pulling on
themselves, not on cables.
- When connecting connectors,
push them against each other
until the lock clicks.
- Do not pull on wiring harnesses
strongly.
- Do not let harnesses be pinched
between parts.
- Route the harness away from hot
components such as the engine
and radiator.
- Protect the harness from sharp
edges by covering the edges with
tape or other suitable materials.
- Apply sealant to grommets at
portions where the harness run
through.
- Do not fasten the harness to
brake pipes or high pressure air
conditioner pipes.
- Fasten the additional harness
to an existing vehicle harness
using tape or tie wraps.
- Bind up extra length of the
harness using a tie wrap.
- If one tie wrap is too short, use
two connected together.
- Check the product and wiring
for installed condition before
connecting the cable to the
battery.
- Check the installed product for
function. Also check lamps,
horn, wipers, etc. for proper
operation.
Before installation When installing or removing parts
Wiring
Clamping harness After installation
click!
click!
click!
Bee
p