Owner`s manual

- 27 -
INSTALLATION PROCEDURES FOR ENDEAVOR
A. PREPARATORY WORK
1) Confirm that the ignition key is removed and all the
electrical switches are off. Then disconnect the
battery (–) cable from the battery.
2) Remove the following parts in accordance with the
workshop manual.
1. Side cover
2. Lower panel
3. Combination meter assembly
4. Steering column upper cover
5. Steering column lower cover
6. Instrument panel under cover
7. Cowl side trim
8. Front pillar trim
B. ROUTING THE HARNESS
1) Route the harness ③ along the vehicle harness as shown in the following two drawings.
Check
Do not fix the harness ③ yet. It should be fixed after completing all the connecting works.
Caution
!
Note
Details of sections C to H are shown in the following steps.