Owner`s manual

- 24 -
H. INSTALLING THE HOOD SWITCH (vehicles without theft alarm system)
In order to install this system on a vehicle without the theft alarm system, the hood switch (sold separately)
and the sub harness for hood switch ⑧ must be installed.
1) Release the 2-pin connector (female) fixed with the
black tape near the left headlamp in the engine
compartment.
2) Remove the front holder of the 2-pin connector.
Install the terminal of the sub harness for hood switch
⑧ to the open cavity (No. 1) of the connector.
3) Reinstall the front holder to the connector. It clicks
when it seats in position.
4) Route the sub harness ⑧ along the front harness
and connect it to the ground point securely. Refer to
the workshop manual for the correct tightening torque.
5) Install the hood switch (sold separately). Connect
the 2-pin connector (female) to the hood switch.
Check