Owner`s manual

- 13 -

H. ROUTING THE HARNESS TO THE

COMBINATION METER

1) Route the quick splice connector with white/black

wire and the ground terminal of the harness ③ to

the combination meter.

2) Connect the quick splice connector with white/black

wire to the black/white wire from the No. 13 terminal

of the 18-pin connector for combination meter.

3) Wrap the connector with the urethane sheet C ④

as shown in the drawing to prevent the connector

from rattling.

4) Tighten the ground terminal of the harness ③ with

the instrument panel mounting nut as shown in the

drawing.

5) Cut the urethane sheet D ④ to an appropriate size

and fix the ground terminal wire to the instrument

panel with it to prevent the wire from dangling.

I. CHECKING AFTER INSTALLATION

1) Check that all the harnesses are connected correctly while referring to the wiring diagram.

2) Check that all the connectors are connected securely.

3) Fix the harnesses properly to prevent them from interference and dangling using the tie-wraps ⑦ and vinyl

tape.

Check

Refer to the workshop manual for the tightening

torque of the mounting nut.

Note