Owner`s manual

- 12 -
4) Disconnect the 3-pin connector of the instrument
panel harness from the junction block. Draw out the
No. 3 terminal from the connector and install the
terminal with red/green wire of the harness ③ to
that cavity. Reconnect the connector to the junction
block.
5) Disconnect the connector half on the 1-pin connector
(male) of the harness ③. Install the terminal drawn
out in step 4) to that connector half and reconnect it
to its original position.
6) Fix the 1-pin connector as shown in the drawing
using the tie-wrap ⑦.
7) Bundle the excess length of the harness ③ leading
to the 1-pin connector and fix it to the instrument
panel harness using the tie-wrap ⑦.
Check