Owner`s manual

- 11 -
G. ROUTING THE HARNESS AROUND
THE ETACS-ECU
1) Connect the 1-pin connector (female) of the harness
③ to the 1-pin connector of the front harness taped
with the black tape on the front harness at the front of
the ETACS-ECU.
2) Connect the three quick splice connectors of the
harness ③ to the wires from the gray and white
24-pin connectors connected to the ETACS-ECU
as follows.
3) Bundle the excess lengths of the wires and fix them
to the vehicle harness using the tie-wraps ⑦.
The connector drawings show the positions of the
terminals as seen from the front (arrow direction)
of the connector.
Note