Service Manual

Fixing the indoor coil thermistor

There are 2 forms of parts for fixing the indoor coil thermistor.

NOTE:

Take care to avoid loss and accidental falling of the clip-shape part inside the unit.

Mount the clip-shape part on the marked position.

Do not pull the lead wire when removing the indoor coil thermistor.

Holder shapeClip shape

When fixing the indoor coil thermistor

to the clip-shape/holder-shape part, the

lead wire should point down.

1. Set the indoor coil

thermistor in the center of

the clip-shape part.

2. Check the (marked)

mounting position.

3. Mount the

clip-shape par

Position and procedure for mounting the clip-shape part

About the

same length

Issued: Jun. 2017. No. OBH732 REVISED EDITION-C

Issued: Mar. 2016. No. OBH732 REVISED EDITION-B

Issued: Nov. 2015. No. OBH732 REVISED EDITION-A

Published: Sep. 2015. No. OBH732

Made in Japan

Specifications are subject to change without notice.

HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN