Service Manual

OPERATING PROCEDURE PHOTOS
1. Removing the cabinet and the panels
(1) Remove all the screws of the service panel, and remove
the service panel.
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Remove all the screws of the top panel, and remove the
top panel.
(4) Remove all the screws of the cabinet, and remove the
cabinet.
(5) Remove all the screws of the back panel, and remove the
back panel (Photo 3).
102
DISASSEMBLY INSTRUCTIONS
12
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with the connector shown below
has the locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are following 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<Detaching method of the terminal with locking mechanism>
Connector
Sleeve
Locking lever
12-1. MXZ-2C20NA2
NOTE: Turn OFF the power supply before disassembly.
Photo 2
Photo 1
Screws of the cabinet
Screws of the
top panel
Screws of
the cabinet
Screws of
service
panel
Screws of the
top panel
Screws of
the cabinet
Screws of
the cabinet
Screws of the
sub panel
Photo 3
Screw of the rear guard
Screws of the
back panel
Screws of the
back panel
Screws of
the back panel
OBH702F