Specifications

AUTOMATIC TRANSMISSION -
On-vehicle Service
23-62
LINE PRESSURE ADJUSTMENT
23100170122
1. Discharge the automatic transmission fluid, and then
remove the valve body cover.
2. Turn th e adjusting screw shown in the illustration at left
to adjust the underdrive pressure to the standard value.
The pressure increases when the screw is turned to the
left.
NOTE
When adjusting the underdrive pressure, adjust to the
middle of the standard value range.
Standard value: 1,010 - 1,050 kPa
Change in pressure for each turn of the adjusting screw:
35 kPa
3. Install the valve body cover, and pour in the standard
volume of automatic transmission fluid.
4. Carry ou t a hydraulic pressure test. (Refer to P.23-56.)
Readjust the line pressure if necessary.
SELECTOR LEVER OPERATION CHECK
23100130090
1. Shift selector lever to each range and check that lever
moves smoothly and is controlled. Check that position
indicator is correct.
2. Check the selector lever can be moved to each position
(by button operation as shown in the illustration).
3. Start the engine and check if the vehicle moves forward
when the selector lever is moved from N or D, a n d moves
backward when moved to R.
4. When the shift lever malfunctions, adjust control cable
and selector lever sleeve. Check for worm shift lever
assembly sliding parts.
Adjusting
screw
Push button
Button not pressed
Button pressed