Specifications

AUTOMATIC TRANSMISSION -
On-vehicle Service
23-50
4. Loosen the inhibitor switch body mounting bolts and the
turn the inhibitor switch body so the hole in the end of
the manual control lever a n d the hole (cross section A-A
in the figure on the left) in the flange of the inhibitor
switch body flange are aligned.
5. Tighten the inhibitor switch body mounting bolts to the
specified torque. Be careful at this time that the position
of the switch body is not changed.
6. Gently pull the transmission control cable in the direction
of the arrow, and then tighten the adjusting nut.
7. Check that the selector lever is in the “N” position.
8. Check that each range on the transmission side operates
and functions correctly for each position of the selector
lever.
10 - 12 Nm
Mounting bolts
Manual
control lever
Section A-A
Hole in end
Hole in
flange
Manual control
lever
Inhibitor
switch body
A
A
Adjusting nut
12 Nm
Manual control lever