Specifications

AUTOMATIC TRANSMISSION -

On-vehicle Service

23-48

9. Reconnect the hose which was disconnected in step 1

above, and firmly replace the oil level gauge.

10. Start the engine and run it at idle for 1 - 2 minutes.

11. Move the selector lever through all positions, and then

move it to the N position.

12. Check that the fluid level is at the COLD mark o n the

oil level gauge. If the level is lower than this, pour in

more fluid.

13. Drive the vehicle until the fluid temperature rises to the

normal temperature (70 - 80_C), and then check the

fluid level again.

The fluid level must be at the HOT mark.

NOTE

The COLD level is for reference only; the HOT level should

be regarded as the standard level.

14. Firmly insert the oil level gauge into the oil filler tube.

OIL FILTER REPLACEMENT

23101050067

1. Use the special tool (MB991610) to remove the automatic

transmission oil filter.

2. Clean the filter bracket side mounting surface.

3. Apply a small amount of automatic transmission fluid to

the O-ring of the new oil filter.

4. Use the special tool (MB991610) to install the automatic

transmission oil filter.

NOTE

Tightening torque: 12 Nm

5. Check the quantity of the automatic transmission fluid.

(Refer to P.23-46.)

THROTTLE POSITION SENSOR ADJUSTMENT

23100190142

Refer t o GROUP 13A - On-vehicle Service.

ACCELERATOR PEDAL POSITION SENSOR

ADJUSTMENT <Vehicles with TCL>

23100250048

Refer t o GROUP 13A - On-vehicle Service.

Apply ATF

to O-ring