Specifications

AUTOMATIC TRANSMISSION -
On-vehicle Service
23-47
AUTOMATIC TRANSMISSION FLUID REPLACEMENT
23100100251
If you have a fluid changer, use this changer to replace the
fluid. If you do not have a fluid changer, replace the fluid
by the following procedure.
1. Disconnect the hose shown in the illustration which
connects the transmission and the oil cooler (inside the
radiator).
2. Start the engine and let the fluid drain out.
Running conditions: N range with engine idling
Caution
The engine should be stopped within one minute after
it is started. If the fluid has all drained out before
then, the engine should be stopped at that point.
Discharge volume: Approx. 3.5 L
3. Remove the drain plug from the bottom of the transmission
case to drain the fluid.
Discharge volume: Approx. 2.0 L
4. Replace the oil filters. (Refer to P.23-48.)
5. Install the drain plug via a new gasket, and tighten it
to the specified torque.
Tightening torque: 32 Nm
6. Pour the new fluid in through the oil filler tube.
Adding volume: Approx. 5.5 L
Caution
Stop pouring if the full volume of fluid cannot be
poured in.
7. Repeat the procedure in step 2.
NOTE
Drain the fluid from the cooler hose 7 L at least. Then
drain the fluid a little a nd check the fluid for dirt.
If it has been contaminated, repeat the steps 6 and 7.
8. Pour the new fluid in through the oil filler tube.
Adding volume: Approx. 3.5 L