Specifications

AUTOMATIC TRANSMISSION -
Troubleshooting
23-43
Terminal
No.
Standard valueCheck requirementCheck item
23 Diagnosis control - -
24 Power supply Ignition switch: OFF 0V
Ignition switch: ON Battery voltage
25 Earth Always 0V
26 Earth Always 0V
31 Input shaft speed sensor Measure between terminal No. 31 and No. 43 by
an oscilloscope.
Engine: 2,000 r/min
Selector lever position: 3
Refer to P.23-45,
Oscilloscope
inspection
procedure.
32 Output shaft speed sensor Measure between terminal No. 32 and No. 43 by
an oscilloscope.
Engine: 2,000 r/min
Selector lever position: 3
Refer to P.23-45,
Oscilloscope
inspection
procedure.
33 Crank angle sensor Engine: Idling 2.0 - 2.4 V
36 Idle position switch Engine: Idling 0V
Engine: Other than idling 5V
38 Back up power suuply Ignition switch: OFF Battery voltage
43 Sensor earth Always 0V
44 Oil temperature sensor ATF temperature: 25 _C 3.8 - 4.0 V
ATF temperature: 80 _C 2.3 - 2.5 V
45 Throttle position sensor (TPS)
<Vehicles without TCL>
Accelerator pedal: Released (Engine stopped) 0.5 - 1.0 V
Accelerator pedal position sensor
(APS) <Vehicles with TCL>
Accelerator pedal: Depressed (Engine stopped) 4.5 - 5.0 V
53 Communication with engine-ECU
<Vehicles without TCL>
Communication with TCL-ECU
<Vehicles with TCL>
Engine: Idling
Selector lever position: D
Other than 0 V
54 Communication with engine-ECU
<Vehicles without TCL>
Communication with TCL-ECU
<Vehicles with TCL>
Engine: Idling
Selector lever position: D
Other than 0 V
55 Inhibitor switch P Selector lever position: P Battery voltage
Selector lever position: Other than above 0V
56 Inhibitor switch N Selector lever position: N Battery voltage
Selector lever position: Other than above 0V
57 Inhibitor switch 3 Selector lever position: 3 Battery voltage
Selector lever position: Other than above 0V