Owner`s manual

11-2-3. Oscilloscope Function

(1) Press Oscilloscope on the menu screen of 11-1-1(1).

This function allows you to observe the continuous

waveform, which is loaded from the voltage measurement

terminal, on PC screen using test leads (MB991499, etc).

--Starts the waveform display

--Stops the waveform display

--Switches to Scale mode

: to set the time axis and voltage axis --(2)

--Switches to Trigger mode

: to set trigger conditions --(3)

Note:

DC voltage can be measured in the range of 0-±40V, and

resolution can be measured at 0.1V.

The shortest sampling interval is 500µs.

(2) Setting the Time Axis and Voltage Axis

button switches to the scale mode, and the

buttons can be used to set time axis and voltage axis.

--Changes time axis scale

--Changes voltage axis scale

Note:

Time scale: (10,20,40,100ms/div)

Voltage scale: (1,2,5,8V/div)

(3) Setting Trigger Conditions

button switches to the trigger setting mode, and a

trigger point can be changed by the buttons.

--Up Trigger

--Down Trigger

Measurement Functions