Owner`s manual

77
10-5-2. Data Search & Transfer (PC  V.C.I.)
(a). Automatic Data Search
(b). Database File display
(c). Reprogramming Data Selection
(d). Search
(a). Automatic Data Search
(1) Press Automatic Reprogramming (K-line) button on
the function menu, then the left dialog box appears.
Verify the connection of V.C.I. and harness, and press .
Applicable reprogramming data is searched from database
installed in PC automatically.
(2) Result of the search appears.
Select an appropriate data file with scrolling the list using
buttons, and press to start
transferring the data into V.C.I. memory.
-After completing the data transfer, ECU reprogramming will
start sequentially. (Refer to 10-5-3.)
Note:
Press OK button when message window of device removal
warning comes out at start and end of data transfer.
(b). Database File display
Press Database File Display button on the function
menu, then the left screen appears.
-Reprogramming data files in the hard disk are listed.
-Select an appropriate data file with scrolling the list using
buttons, and press to start
transferring the data into V.C.I memory.
--10 lines scrolling
-After completing the data transfer, ECU reprogramming will
start sequentially. (Refer to 10-5-3.)
Note:
Press OK button when message window of device removal
warning comes out at start and end of data transfer
ECU Reprogramming