Owner`s manual

(b). Select and Load Data

(1) Select “Load RPG file” in main menu by key, and press

Enter key.

(2) Select a reprogramming data file by key, and press Enter

key.

Esc key： Move back to main menu.

Remark:

-The data files are displayed in numeric order of data No..

(From big to small; new to old)

(3) Reconfirm the data file No., and press Enter key to start

transferring the data into V.C.I. built-in-memory.

Esc Key： Cancel

(4) Progress is displayed on monitor

* mark is increased by steps.

(5) After completing data transfer, ECU reprogramming starts

sequentially.

For next steps, Refer to 10-4-4.

(c). (Special case)

(1) If V.C.I. has already stored the reprogramming data, select

“ECU Reprogram” in main menu, and press Enter key.

(Refer to 10-4-2.(2)-(4) for setting up the equipments.)

Reprogramming data file No.and program version No. in the

V.C.I. memory are displayed for a few seconds, and then

ECU reprogramming starts sequentially.

For next steps, refer to 10-4-4.

3 Load RPG file

002 VN01111.rpg

003 VN01093.rpg

001 VN02031.rpg

VN02031.rpg

Rewrite ECU?

****

ECU

Reprogramming

Working,

please wait

2 ECU Reprogram

ECU

Reprogramming

ECU Reprogramming