Owner`s manual

(11) Verify the contents of the selection, then press OK button.

(12) After displayed the message “The device can now be safely

removed from the system”, push the lever on the side of PC

card slot and remove the memory card.

Caution:

Do not remove the memory card away unless complete

above method or turn off the PC.

10-4-2. Equipment Set-Up

(1) Insert the Memory card (MB991853), which is storing the

reprogramming data, into the Card adaptor (MB991939)

and insert them into V.C.I. main unit (MB991824)

(2) Connect M.U.T.-III Main Harness B (MB991911) or

A (MB991910) to V.C.I. main unit securely. (Refer to 10-2.)

Note:

Select appropriate harness by instruction below.

- Main harness A: For vehicle only equipping 16 pin data-link-

connector.

- Main harness B: For other vehicles.

- Adaptor harness (12-13): Outlander, Montero (after ‘02MY)

(To connect Main harness B and 13pin data-link-connector)

(3) After verifying the ignition switch position at LOCK (OFF),

connect the M.U.T.-III Main harness B or A to the data-link-

connector.

(4) Turn Ignition switch on, and turn V.C.I. main switch on.

(Do not start engine)

ECU Reprogramming