Owner`s manual

69
10-4. Reprogramming Operation ( V.C.I. alone )
10-4-1. Data transfer (PC  Memory Card)
(1) Start up the M.U.T.-III system.
Insert the Memory card (MB991853) into the Card Adaptor
(MB991939), and then insert them into m-card slot on PC.
The following window appears when the card has been
inserted properly. Wait till the message disappears.
(2) Press Special function button on STV Top Menu.
(3) Select System Function tab,
and press
ECU reprogramming button.
Caution:
-In case an update CD-ROM is set in the PC with update
undone, data update starts. (refer to 10-3-1(4))
(4) Press
Memory card transfer button.
ALL reprogramming data in the M.U.T.-III PC are transferred
to the memory card.
[Caution]
-Do not remove the memory card from PC.
(5) Select a memory card drive, and press button to start
transferring.
ECU Reprogramming