Owner`s manual

34
Chapter 6 Drive Recorder
6-1. How to Record the Data
There are two ways for recording the data, “Recording by V.C.I.alone (6-1-1)”, and “Recording on
PC with displaying data (6-1-2)”. Please select one of them and follow the procedure.
6-1-1. Recording by V.C.I. alone
This section describes the operation for recording data
using only V.C.I. without connecting to PC. However, drive
recorder settings such as items to be recorded or trigger
method are configured using PC.
Please connect V.C.I. into PC and the vehicle, and start
performing the following steps using PC first.
(1) System Select
Select a system for which the drive recorder is to be used
on the System Selection screen.
(For instruction on how to select a system, refer to 3-3-1
)
- The following explanation describes how to set the drive
recorder settings of the MFI system as a representative
example.
(2) Function Select
Press
Drive Recorder button.
(3) Drive Recorder Function select
Press
Record button on the Drive Recorder function menu.
Note:
Data display -- To transfer the recorded data on the V.C.I.
into the PC (Refer to 6-2), or display the data (Refer to 6-3).
Record (Read Setting Conditions)
--Restore past recording conditions so that you can execute
recording under the same conditions as those used with
previously recorded data files. (Refer to 6-1-3)
Data Storing -- The data saved in a removable disk can
be stored into the PC. (Refer to 6-2-2(7))
Drive Recorder <Record by V.C.I. alone>