Service Manual

OPERATING PROCEDURE PHOTOS
1. Removing the panels
(1) Remove the screws fixing the top panel, and remove the
top panel.
(2) Remove the screws fixing the service panel.
(3) Pull down the service panel, and remove the service
panel.
(4) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(5) Remove the screws fixing the front panel, and remove the
front panel.
(6) Remove the screws fixing the back panel, and remove
the back panel.
87
12-1. MXZ-3C24NA MXZ-3C30NA MXZ-4C36NA
MXZ-3C24NA2 MXZ-3C30NA2 MXZ-4C36NA2
Photos: MXZ-4C36NA
MXZ-4C36NA2
NOTE: Turn OFF the power supply before disassembly.
Photo 1
Photo 3
Screws of the service panel
Screws of the front panel
Catch of the front panelCatch of the front panel
Screws of the top panel
Screws of the front panel
Screws of the top panel
Screws of the back panel
Photo 2
DISASSEMBLY INSTRUCTIONS
12
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
OBH702C