Service manual

MSZ-FD25VA MSZ-FD25VAS MSZ-FD35VA MSZ-FD35VAS MSZ-FD50VA MSZ-FD50VAS

NOTE: Turn OFF power supply before disassembling.

OPERATING PROCEDURE PHOTOS

1. Removing the panel

(1) Hold both sides of the front panel and lift the front

panel until it is level. Pull the hinges forward to

remove the front panel.

(2) Remove the horizontal vanes.

(3) Remove the screw caps of the panel. Remove the

screws.

(4) Unhook the lower part ( ) of the panel.

(5) Hold the lower part of both ends of the panel and pull

it slightly toward you, and then remove the panel by

pushing it upward.

Photo 1

(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the

locking mechanism.

Slide the sleeve.

Pull the terminal while

pushing the locking

lever.

Hold the sleeve, and

pull out the terminal

slowly.

Connector

Sleeve

Locking lever

Screws of the panel

Front panel

Horizontal vane

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below.

There are two types (refer to (1) and (2)) of the terminal with locking mechanism.

The terminal without locking mechanism can be detached by pulling it out.

Check the shape of the terminal before detaching.

DISASSEMBLY INSTRUCTIONS

Mitsubishi ilmalämpöpumput huoltaa ja korjaa: Jäähdytinpalvelu RefGroup Oy