Service manual

31
DISASSEMBLY INSTRUCTIONS
10
(1) Slide the sleeve and check if there is a locking lever or not.
(2)The terminal with this connector has the 
locking mechanism.
1Slide the sleeve.
2Pull the terminal while 
pushing the locking
lever.
1Hold the sleeve, and 
pull out the terminal 
slowly.

The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
MSZ-FA25VA MSZ-FA35VA
INDOOR UNIT
OPERATING PROCEDURE
PHOTOS
Photo 1
1. Removing the panel
(1) Press and unlock the knobs on both sides of the front
panel and lift the front panel until it is level, and then pull
the hinges forward to remove the front panel.
(2) Remove the horizontal vane.
(3) Remove the screw caps of the panel.
Remove the screws. (See Photo 1.)
(4) Remove the screw of the front panel driving motor.
(See Photo 2.)
(5) Hold the lower part of both ends on the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
Photo 2
Screws of the panel
Horizontal vane
Front panel
Screw of the front panel
driving motor
OB416_--2qxp 12/2/05 4:26 PM Page 31