Service manual

Wireless Remote Controller
SENDING SECTION-)
LCD
INDICATOR
I FEEL CONTROL
bunon
MASTER CONTROL
bunon
FAN CONTROL
bunon
SET TEMP.
bunon
TIMER CONTROL
bunon
TIME S€lTtNG
bunon
VANE CONTROL
bunon
TOO COOL OKAY TO0 WARM
-Con
POWER
bunon
MSH-12/15DN- Q
I INDOOR UNIT DISPLAY SECTION
POWER DEFROST
MSH-09DW
I FEEL MONITOR
IDDOI
I FEEL MONITOR
I I MSH-12/1IDN
Once the controls are set, the same operation mode can be
repeated by simply turning the POWER switch ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, "3 min. tim&elay function" will
operate to protect system from over load and compressor does
not restart before 3 minutes.
1. "I FEEL CONTROL" operation
(1) Press POWER button on the remote controller. Power
lamp of the indoor unit will tum on with beep tone.
(2) Select the MASTER CONTROL button to "I FEEL
CONTROL". And
I FEEL MONITOR lamp lights with
beep tone.
(3) The operation mode is decided by the initial room
temD. at startina up the operation.
-.
Initial Room Temp.
more than 76F
COOL mode of
"I FEEL CONTROL"
73'F to 76°F
DRY mode of
MGDW :55'~ to 76F I
"I FEEL CONTROL"
less than 73'F
I HEAT mode of
I MSH-09.12.15 1 "I FEEL CONTROL" I
*Once the mode is fixed, the mode will not change by
room temp. afterwards.
*Under the AUTO START timer operation, the mode is
determined according to the room temperature 1 hour
before the set time.
When the system is stopped with the POWER button on
the remote controller, and restarted within 1 hour in "I
FEEL CONTROL" mode, the system operates in previous
mode automatically regardless of the room temp.
When the system is restarted after 1 hour, the operation
mode is decided by the initial room temp. at starting up the
operation.
Example
Previous operation
COOL mode of Restart
"I FEEL CONTROL"
COOL
mode of
or COOL mode
i "I FEEL CONTROL"
OFF
I i
ON
1 hour
9