Instruction manual

Easy Setup

WHEN USING FOR THE FIRST TIME

• Parameters to be adjusted for the IPM motor control

The following parameters are related to the IPM motor control.(Refer to the Instruction Manual of the inverter for the

parameter details.)

: Related parameters, : Non-related parameters, – : No parameter

Parameter

Number

Name FR-A700 FR-F700P FR-F700PJ

1 Maximum frequency

4 Multi-speed setting (high speed)

9 Electronic thermal O/L relay

13 Starting frequency

15 Jog frequency

18 High speed maximum frequency

20 Acceleration/deceleration reference frequency

22 Stall prevention operation level

37 Speed display

55 Frequency monitoring reference

56 Current monitoring reference

71 Applied motor

80 Motor capacity

81 Number of motor poles ––

84 Rated motor frequency –

125 Terminal 2 frequency setting gain frequency

126 Terminal 4 frequency setting gain frequency

144 Speed setting switchover

240 Soft-PWM operation selection

260 PWM frequency automatic switchover –

263 Subtraction starting frequency –

266 Power failure deceleration time switchover frequency –

374 Overspeed detection level

386 Frequency for maximum input pulse ––

390 % setting reference frequency –

505 Speed setting reference

557 Current average value monitor signal output reference current

820 Speed control P gain 1

821 Speed control integral time 1

824 Torque control P gain 1 ––

825 Torque control integral time 1 ––

870 Speed detection hysteresis

885 Regeneration avoidance compensation frequency limit value

893 Energy saving monitor reference (motor capacity)

C14(918) Terminal 1 gain frequency (speed) ––

C24(923) Frequency setting voltage gain frequency (built-in potentiometer) ––