Instruction manual

36
Explanation of Window
1.7 Explanation of Window
The following section describes FR Configurator window.
1.7.1 Main frame
The Main frame (main window) of FR Configurator consists of three areas.
• Navigation area (Refer to page 38)
An area for showing information of the registered inverter, or for making settings. "Test Operation", "System Settings",
"Setting Wizard", and "Troubleshooting" are available in this area.
• Monitor area (Refer to page 40)
An area for showing obtained monitor data of the inverter. "Graph", "I/O Terminal Monitor", "Machine Analyzer", "Batch
Monitor" are available in this area.
• System area (Refer to page 39)
An area for showing and read/write parameters, or for converting from parameter setting of conventional model. "Parameter
List", "Diagnosis" and "Convert" are available in this area.
• Explanation of Main frame
No. Name Function and description
Refer
to
Page
A
Title bar
"FR Configurator SW3" is displayed on the title bar. If a system file has been read, or has
been saved, the file name is displayed.
—
B
Menu bar Each function is available by selecting from the menu. 41
C
Tool bar Each function is available by clicking icons of the tool bar. 41
D
Status bar The model name, Operating status, etc. are shown. 43
E
Split line Adjustment of System area size and Monitor area size is available. —
F
Conceal button Conceals the Monitor area and System area. —
G
Minimize button Minimizes the Main frame window size of FR Configurator. —
H
Maximize button Maximizes the Main frame window size of FR Configurator. —
I
Close button Closes FR Configurator. —
D
B
A
Monitor area
C
System area
E
Navigation area
F
F
H
G
I
(Refer to page 38)
(Refer to page 40)
(Refer to page 39)