Instruction manual

28
Setting of Operation Mode of the Inverter
Refer to the following table to select the appropriate operation mode for the connection. Switching of the operation mode is
available at "Test Operation" window (Refer to page 97) in Navigation area.
Refer to the Inverter Instruction Manual (Applied) for details of each parameter.
Controllability through communication
·Monitoring and parameter read can be performed from any operation regardless of the operation mode.
FR-A700, A701, F700, F700P series
Operation
Location
Condition
(
Pr. 551
Setting)
Operation
Mode
Item
PU
Operation
External
Operation
External/PU
Combined
Operation
Mode 1
(
Pr. 79 = 3)
External/PU
Combined
Operation
Mode 2
(
Pr. 79 = 4)
NET
Operation
(when RS-485
terminals are
used)
*6
NET Operation
(when
communication
option is used)
*7
Control by RS-485 communication from PU connector
2
(PU
connector)
Run command (start)
Run command (stop)
*3 *3 *3
Running frequency
setting
Monitor
Parameter write
*4
*5
*4 *4
*5
Parameter read
Inverter reset
Other than
the above
Run command (start)
Run command (stop)
*3 *3 *3 *3 *3
Running frequency
setting
Monitor
Parameter write
*5 *5 *5 *5 *5
Parameter read
Inverter reset
Control by communication from
RS-485 terminals
1
(RS-485
terminals)
Run command(start,
stop)
Running frequency
setting
Monitor
Parameter write
*4
*5
*4 *4
*5
Parameter read
Inverter reset
Other than
the above
Run command
(start, stop)
*1
Running frequency
setting
*1
Monitor
Parameter write
*5 *5 *5 *5
*4
*5
Parameter read
Inverter reset
*2