Instruction manual

174
Appendix 1 Supplementary Software MEL file convert software
Appendix 1-1 Introduction
MEL file convert software is a dedicated software to convert former system files (*.mel), which are created in FR Configurator
SW2, to the system files (*.me3), which correspond to FR Configurator SW3. Please note in advance that Mitsubishi does not
offer any guarantee regarding MEL file convert software.
MEL file convert software will be installed in the folder where FR Configurator SW3 is installed. To start this software, double
click "Melconv_e.exe."
Note
· System files of setup software SW1 (*.mel) are not supported.
· When using Windows Vista or Windows 7, "User Account Control" window may appear for the start up of MEL file
convert software. If the window appears, select [A
llow] in the "User Account Control" window. (Refer to page 6)
Also, "Program Compatibility Assistant" window may appear when closing MEL file convert software. If the window
appears, select "This program installed correctly" in the "Program Compatibility Assistant" window. (Refer to page 6)
· Parameter increments information is not stored in source system files (*.mel). As a result, increments in the parameter
list are not displayed properly in a converted system file (*.me3). To display correct increments, perform parameter
write from the parameter list to the inverter. (Parameters are written to the inverter correctly regardless of their
displayed increments.)
MEL file ME3 file
Melconv_e.exe
Source Target