Instruction manual

136
Graph (Monitor Area)
4.9.1 Basic flow of sampling
1) Sampling setting
Set sampling items. Changing of the sampling mode (High Speed or Monitor), sampling interval or sampling time, etc. is
available for your purpose. When starting sampling with using a trigger, make a trigger setting.
2) Start sampling
Click to start the sampling when sampling item is set already. If the trigger is set, sampling starts when the
trigger condition is satisfied during "Waiting for Trigger" state which comes after "Sampling Pre-trigger Data" state.
3) Sampling complete
Sampling stops in the following condition.
•When elapsed time from the beginning of the monitoring exceeds the sampling time
•When is clicked
4) Graph display
You can change a scale of the graph, show a numeric value of a wave at where cursors is laid, or show effective value of
between any 2 points, maximum value, and minimum value. Exporting of graph data (Refer to page 94) for saving as a file is
also available.
Note
If an normal communication is not maintained (communication error, etc.), the sampling stops.
If an fault occurs during sampling, sampling continues.
During sampling, other communication tasks such as parameter reading are unavailable.