Instruction manual

132

Convert (System Area)

( ) indicates parameter number for the FR-F500J series.

(1) The following parameters are not converted. Make a setting from "Parameter List" as required.

• Pr. 133 PID action set point

• Pr. 160 (P30) Extended function display selection

• Pr. 900, Pr. 901 (FM, AM output terminal calibration)

• Pr. 991 PU contrast adjustment

(2) The following parameters are adjustment parameters. Parameter readjustment according to the machine is

recommended after converting.

• Pr. 0 Torque boost

• Pr. 12 DC injection brake operation voltage

• Pr. 245 (P95) Rated slip

• Pr. 246 (P96) Slip compensation time constant

• Pr. 902 to 905, 922, 923 (C3, C4, C6, C7) (frequency setting input calibration parameter)

(3) When Automatic torque boost is selected (Pr.98 Motor capacity is not "9999") for the FR-F500J series, note the following

precautions.

• Tuning and parameter setting of the target inverter are recommended.

• When SF-HR or SF-HRCA type motor is used, set Pr.71 = "40, 43, 50, 53" after writing the converted parameters to the

target inverter.

(4) Communication related parameters (Pr.117 to Pr.124 (n1 to n7, n11)) are also converted. Depending on a setting,

communication may not be established after writing the parameters. For example, if Pr.122 (n6) PU communication check

time interval = "0" (initial value), changing to the command source operation mode causes a communication fault

(E.PUE).

(5) The following functions have different behavior due to specification changes. Refer to the Instruction Manual of FR-

F700PJ for details.

• Since the formula of Pr.23 Stall prevention operation level compensation factor at double speed has been changed, the

operation level of the stall prevention at double speed changes if the setting has been changed greatly from 100%.

• Pr.992 (n16) PU main display screen data selection is integrated into Pr.52 . Setting Pr.52 changes both operation panel

display and PU display.

(6) The following function is not converted since it has been deleted from the FR-F700PJ series.

• Pr.93 PID action set point for PU operation