Instruction manual

Installation and Uninstallation

1.3 Installation and Uninstallation

1.3.1 Installation of FR Configurator

To use FR Configurator (FR-SW3-SETUP-WE), the files included on the setup disk (CD-ROM) or the downloaded file must be

installed onto the personal computer.

Check the following points before the installation.

· Close any other applications that have already been started.

· For the installation, log on as an administrator (Administrator account) and start installation.

· If an inverter is connected by the USB cable, disconnect the USB cable.

· Installation files are compressed. Copying the files does not start FR Configurator yet. Install the software using the setup

program.

· To install the software, follow the installation procedure in Windows screen.

· If VFD Setup Software (FR-SW1-SETUP-WE) of an older version (CD-ROM) is installed after the installation of FR

Configurator, FR Configurator does not operate. In this case, please uninstall FR Configurator (Refer to page 10), and then

install FR Configurator again.

· If an older version of FR Configurator has been installed, the older version will be uninstalled during the installation.

· In an operation system with antivirus / security software, a warning may appear when installing FR Configurator. If a

warning appears, permit the installation of FR Configurator according to the setting procedure of your antivirus/security

software.

· FR-SW3-SETUP-WE and FR-SW3-SETUP-WE CC-Link Seamless are in the same software package. When FR-SW3-

SETUP-WE is installed, FR-SW3-SETUP-WE CC-Link Seamless is installed together.

Installation procedure

The following section describes the procedures of installing FR Configurator.

(1) Insert the CD-ROM to an available CD-ROM drive. Installation starts automatically.

REMARKS

Installation can be started with double-clicking the icon of CD-ROM drive or the following procedure.

1)Choose the [Run...] command from [Start] menu.

2) "Run" window appears.

3)Type "D:\SETUP" (with one-byte characters) in "O

pen" field and click . (When CD-ROM drive is D drive)

Note

· When using Windows Vista or Windows 7, the following window may appear during the installation. Click "Continue."

Select "Continue"