Instruction manual

122
Convert (System Area)
7) Check the information of the source inverter and target
inverter. Click and proceed to the next
according to the messages appear in the screen to
convert parameters.
8) Click when "Parameter converting is
finished." is displayed.
9) Results of parameter converting is shown in "Convert"
window.
10) Click in "Convert" window to display
"Parameter Saving".
11) Check "Reflect in a Parameter List of the Selected
Station", and click to reflect the converted
parameter setting into the Parameter List.
If a station has not finished model setting or the inverter
model is different, the station is unavailable to select.
12) When saving the converted parameter setting as a file,
check [Save As]. Specify the file location, and click
to save the converted parameter setting into
a parameter file (PR3).
REMARKS
• Following confirmation dialog is displayed when applying the converted parameter setting.
Click to apply and overwrite the parameter setting.
• If a nonexistent parameter is added to the source, the nonexistent parameter data will not be applied to the target.
• Depending on the connected model, FR Configurator may not recognize the source inverter at the detection. In that case, the
following window appears. Please select the connected model from the selection.
Click to convert
parameters
Specify the file
location
Select the
connected model
from the selection