Instruction manual

121
Convert (System Area)
4
FUNCTION
(3) When converting from the Connected Inverter through Communication
POINT
Perform during a inverter stop. Do not input a start command.
1) Check that FR Configurator is ONLINE. (Click
in "System Setting" to switch to ONLINE.)
2) Click in "Convert" window to display
"Convert Method".
3) Choose "Convert from the Connected Inverter through
Communication". Click after selecting.
4) Click in "Connected Inverter Detection"
window. Check the inverter detection result, and click
.
5) Select the target inverter on the "Target Inverter"
window, and the convert setting is finished. Click
, and proceed to the next according to the
message on the window.
6) The value of some of the source parameter is available
for changing. When changing the parameter setting
value, enter a changed value in Setting field.
When the convert setting is finished, in
"Convert" window becomes available. Click
to display "Convert Confirmation".
REMARKS
If FR-E500 is connected to the station number
where FR-E700 is set for system setting,
switching to ONLINE will display a
communication error dialog. In this case, click
OK, and proceed converting.
[Convert from the
Connected Inverter
through Communication]
Click to detect
inverter
Select the target
inverter
Click to display "Convert Confirmation"