Instruction manual

120
Convert (System Area)
9) Results of parameter converting is shown in "Convert"
window.
10) Click in "Convert" window to display
"Parameter Saving".
11) Check "Reflect in a Parameter List of the Selected
Station", and to reflect the converted
parameter setting into the Parameter List.
If a station has not finished model setting or the inverter
model is different, the station is unavailable to select.
12) When saving the converted parameter setting as a file,
check [Save As]. Specify the file location, and click
to save the converted parameter setting into
a parameter file (PR3).
REMARKS
• Parameter file (PRM) is a text format file. If an nonexistent parameter is added to
the source, a caution shown on right appears. The data about nonexistent
parameter is not converted.
• If the parameter file (PRM) is broken, a caution shown on right appears when
reading the file. In this case, select a normal parameter file, and perform read file
again.
• If the parameter file (PRM) is a one from not-compatible inverter, a caution shown
on right appears. In this case, select a parameter file of the compatible inverter,
and perform Read File again.
• In some versions of the setup software SW1, calibration parameter settings are not included in the saved parameter file
(PRM). After a convert, check the calibration parameter settings.
Specify the file
location