® MITSUBISHI ELECTRIC STRIP-TYPE AIR CONDITIONERS OPERATING INSTRUCTIONS MSO09NW MS12NN MS15NN MS17NN Mir. SLIM re tA CONTENTS CONTENT eee. SAFETY PRECAUTION NAME OF EACH PART .. PREPARATION BEFORE OPERATION “| FEEL..." AUTO OPERATION. MANUAL OPERATION (COOL, , EAN] ., AIRFLOW VELOCITY AND DIRECTION Al SWING OPERATION. TIMER OPERATION (KNOCKOFF TIER) WHEN THE AIR CONDITIONER 15 NOT GOING TO BE USED FOR A LONG TIME.
‘= 7} ) SAFETY PRECAUTIONS * This alr conditioner is for house hold use. © Before using the unit, carefully read these “satiety precautions” and use correctly. * Since these cautionary rems shown here are important for safety, be sure to observe them. Marks and their meanings are as shown below.
A WARNING Do not insert your finger or stick, etc. into the air inlet/air outlet. « Since the tan rotates al high speed, this may cause an injury. Do not expose the skin to cool air directly for longtime. « This could damage your health, of = When an abnormality occurs, stop the air conditioner, and turn off the breaker, Repair or relocation should note done by the customer. » If this is done incorrectly, it may cause a lire, electric shook, injury by dropping of the unit, water leakage, eic.
~ f — SAFETY PRECAUTIONS A CAUTION When the air filter is to be removed, do not touch the metal parts of the indoor RLY « lt may cause an injury. insure power is turned off at the circuit blear before cleaning the unit. » Since the fan rotates at high speed during operation, it may cause an injury. DLE TREE ER with wet hands. « It may cause an electric shock. PR ial conditioner with ware + Water may enter the unit and degrade the insulation, if may cause an electric shock.
/A\ WARNING EEE operated for long periods of time, disconnect power to the system PC i Do not step on the indoor/outdoor unit and donotputanythingonit. ot may cause an injury through dropping of falling down. Do not leave on installation stand which is damaged. » The unit may drop or downfall and cause an injury. Do not operate for a long tire in high humidity, e.g.
Remote controller ET Operation display section i COCO NT Lessie] ON/OFF@ TOO [6 ATOP WARM COOL OPERATION SELECT button TEMPERATURES button rrr FAN VANE . FAN SPEED CONTROL button CD [a VANE CONTROL button SWING yw—— SECT ELK {TIME SET button) {This diagram shows an overall view.
) PREPARATION BEFORE OPERATION Indoor unit Turn the breaker ON, ‘Remote controller (how to set the current time) Remove the back lid and insert Press the 5 and & button batteries, And then reattach the (TIME SET button) to set the back lid. Lz current time. > RUNOFF TOO [TACO SS warm cool @FIAT STOP oO MIN. pre = After batteries are replaced, press the reset button.
Handling of the remote controller » The range that the signal can reach is about 6 m when pointed at the front of the indoor unit, « When the button is pressed, one or two beeps will be heard trim the indoor unit. if no sound is heard, operate again. « Use the remote contralto carefully, it iris dropped, thrown or gets wet, it may not operate. When installing on a wall, etc.
With the “| FEEL...” auto operation mode, the optimum room condition can be set automatically by one touch operation. AUTO BOFFO MEH) ATOP WARM COOL oO START STOP oO HR. o MIN. CLOCK “I FEEL...” AUTO OPERATION ® To start operation: ONION Press the (0 button. ‘When the “| FEEL...” is displayed, the air conj toner is automatically controlled at the optimum temperature. ® To stop operation: ONION Press the (O) button. When about 15 min.
Description of “| FEEL...” mode ey Details of operation TAT According 10 the room temperature when the operation Seg ht starts, the operation mode is automatically selected between = COOL and DRY. However, when operation is started again “9 Ne In within 2 hours after the operation is stopped, the same 7 operation mode before it is stopped is selected. The operation mode selected first is net changed even if the room temperature changes.
=¥ +44) MANUAL OPERATION (COOL, DRY, FAN) % ) To select the “COOL”, “DRY” or “FAN” mode ) With this operation mode, the temperature and airflow direction can be finely Press the ON OFF OD hut ion. adjusted by selecting the O operation mode. Bh Select the operation mode by pressing the moo: button. Each time this button is pressed, the operation mode is changed in sequence, from “1 “COOL”, “DRY”, "FAN", o To stop operation: BB Press the 6 © button.
CONVENIENT INFORMATION [7] For effective cooling ®Closethewindowsandpull (Paste a heat shield film (© Block the outdoor unit from down blinds. Sunshine is {generally available} on the direct sunlight. This saves reduced and cooling window. Heat entering the energy. efficiency increases. room is reduced. | The humidity at which humans feel comfortable When air contains too much moisture, humans feel clammy. Humidity is related with temperature and wind.
8 /3%) AIRFLOW VELOCITY AND DIRECTION ADJUSTMENT To change the AIR FLOW velocity, press the “button. AIR FLOW velocity and direction can Each time the button is pressed, fan speeds changed be selected as required. in sequence, from » [Lola, [Med] [Hil AUTO. * To condition the whole room, use the «sf {HI} mode. To change the AIR FLOW blowing direction vertically, press the 2 button. Each time the button is pressed, angle of horizontal vane is changed in sequence, from AUTO.
AUTO AIR FLOW DIRECTION CONTROL OPERATION vane * When the AUTO mode is selected with the (> bunion, the position of the horizontal vane are automatically set to correspond to the operation mode to perform effective operation, (1) COOL, DRY (2) FAN The air flow blows level. The air flow blows down BB To change the horizontal direction of the AIR FLOW move the vertical vanes manually.
For AIR FLOW to reach all corners of the room or to strike a point directly, use the swing operation. BOFFO ¥TOO 0) ATOP WARM COOL 15 ) Perform the following operations while the unit is running. ) P sw button. reds the S + To release the SWING operation mode; Pri SWING button again. ess the the Fd button is pressed during swing operation, swing operation is released.
tJ) TIMER OPERATION (ON/OFF TIMER) #t is convenient to set the timer for the v time when you go to bed, when you get C How to set the ON timer ) home, when you get up, etc. Press the °2% button to set the ON timer mode during operation. Each time the button Is pressed, the ON timer mode alternates between ON and OFF, 2] Set the time of the timer using the J and 2% buttons.
Tendinitis not going robe used for a long time: EB Perform FAN operation for 3 or 4 hours to dry the inside of the air conditioner. B Turn off the breaker. CAUTION Turn off the breaker when the air conditioner is not going to be used for a long time. Remove the batteries from the remote controller. 17 WHEN THE AIR CONDITIONER IS NOT GOING TO BE USED FOR A LONG TIME When rr air conditioner is to be used again: Clean the air filter and install it in the indoor unit. (Deter to page 18 for cleaning it.
CAUTION When the unit is to be cleaned, switch off and turn off the breaker. Since the fan rotates at high speed during operation, it may cause an injury ) MAINTENANCE Cleaning the indoor unit Hn Clean using soft dry cloth. Do not use gasoline, benzine, polishing powder and detergent. And do not spray with insecticide. The unit may be damaged.
When the front panel is to be opened, do not open it up to the level position. Hf you do, the front panel may come off. fe EL TR LTE: SiH ETI GL LEE TA Ribbentrop panel, removingireplacing the filter A Caution YL Ares ‘When the air filter is to be removed, do not touch the metal parts of the indoor unit, it may cause an injury, Clean dirt from the air filter using a vacuum cleaner or by washing with water. ® If dirt is conspicuous, wash with a solution of detergent in lukewarm water.
LIAR TIRE FILTER/AIR CLEANING FILTER (OPTION) Lim deodorizing filter/air cleaning filter, deodorizing filter replace 3 EB Remove the air filter. Remove the deodorizing filter (gray sponge type). Deodorizing filter ® Cleaning is necessary about once every 2 weeks. However, dirt is conspicuous, clean more often. ® When the color of the filter is not restored even it the filter is washed following the procedure shown on page 18 or when the filter becomes black, replace the filter with a new one.
VILLEIN JW BRIER HAS OCCURRED HEIFETZ Bem Be F) Question Answer (not a malfunction) The air an 7 conditioner a= cannot This protects the air conditioner by operated about s instructions from the microprocessor. Wait. for 3 minutes when re-started. Crack sound is heard. ® This sound Is generated by the expansion/ contraction of the front panel, etc, due to changes of temperature. Room smells funny. | ® The air conditioner sucks an odor adhering 8 wall, carpet, furniture, cloth, etc.
*) OCCURRED WHEN YOU THINK THAT TROUBLE HAD Question Answer (not a malfunction) A mechanical sound is heard Ie from the indoor © unit. W This is the sound of the switch turning ON/ OFF the fan or compressor. Water leaks from the outdoor unit. W During cooling operation, pipe or pipe connector section are cool and cause water condensed. The air conditioner does not operate [i] =) when the main = power is turned on.
BE WWM BEA wees w= ea oe AND INSPECTION 8 Avoid installing the air conditioner in the following places. ® Where flammable gas could leak. ~ my Do not install the unit where flammable gas could leak. | 1f gas leaks and collect around the unit, may cause an explosion, ® Where there is much machine oil. # Salty place such as the seaside. M Where sulfide pas is generated such as a hot spring.
2 MITSUBISHI ELECTRIC VAC Advanced Products Division 3400 Lawrencium Suwanee Road » Suwanee, Georgia 30024 Toll Free: 800-433-4822 » Toll Free Fax: 800-889-9904 www.mrslim.com Specifications are subject to change without notice.
