Specifications

96

AJ65BT-G4-S3
Peripheral Device Connection Module
● Performance Specifications
Model name
Peripheral device connector
Station type
Number of occupied stations
Allowable momentary
power failure period
Applicable solderless terminal
Module mounting screws
Applicable DIN rail
24 VDC internal current consumption
External power supply
(for driving the module)
Weight
External dimensions
AJ65BT-G4-S3
D-sub 25 pin 1 channel
Intelligent device station
1 stations (32 points each for RX/RY, 4 words each for RWr/RWw)


RAV1.25 to 3.5, RAV2 to 3.5 (compliant to JIS C 2805)
M4 x 0.7 mm x 16 mm screws or larger
Possible to mount on a DIN rail
TH35-7.5Fe, TH35-7.5Al, TH35-15Fe (compliant to JIS C 2812)


24 VDC (15.6 to 28.8 V)


It is possible to perform remote operation via CC-Link.
 Online operations such as PC write, PC read, monitoring and test can be performed from peripheral
devices to QCPU, QnACPU and ACPU modules at remote locations on the CC-Link network.
It is possible to connect various peripheral devices.
It is possible to connect peripheral devices equipped with MELSEC PLC programming software.
See page 154 for the general specifications.
Cable for connecting AJ65BT-G4-S3 and peripheral device
＊(Please refer to the operating manual for the MELSEC PLC
programming software to be used.)
＊An RS-422/RS-232 conversion cable is required to connect a PC to
this module.
CC-Link dedicated cable
Remote device station
Remote I/O station
Master station Local station
AJ65BT-G4-S3
(intelligent device station)
Peripheral device
RS-422
interface
MELSEC
PLC programming software
Product
Description
Product
Description
Master/Local
Remote I/OAnalog
High-Speed
Counters
PositioningHMIRepeatersRS-232
Interfaces
OptionSoftwareOthers
Technical
Information
CC-Link
-
CC-Link / LT
Bridge Modules
Support PC
Interfaces
Peripheral
Device
Connection