Specifications

27
Control Airflow Angle for Better Coverage
With the wired remote controller, four different airflow positions
can be set. The Autovane feature when in use during cooling,
permits the angle to self-adjust into a horizontal position and
circulate cold air more effectively.
During heating, the vane directs the hot air downward toward the
floor, where it will rise and circulate, keeping your room comfortable
from top to bottom.
i-see
™
Sensor Optional Accessory
The field-installed i-see sensor accessory improves the operation in the room by sensing and
controlling for the temperature felt by the room’s occupants to help prevent over cooling or under
heating. Taking floor temperature samples five times every 40 seconds over a 160˚ angle of the
surface area. Sensors alter the Auto Fan setting and Vane control setting to account for ambient room
temperature fluctuations from the set point.
Built-in Drain Pump
The PEA indoor unit features a built-in drain pump that lifts condensation up to
21-11/16 inches above the drain pan and upto 27-9/16 inches for the PEAD indoor
unit. The unit’s fail-safe mechanism recognizes when there is a high level in the
condensate pan and shuts off the indoor fan and the outdoor unit compressor to
prevent overflow.
When installed, the PEA/PEAD indoor unit utilizes
short duct runs allowing for the air-conditioning of
adjacent spaces or extending the range of distrib-
uted capacities within a single zone with very little
visual impact to the conditioned area. With features
like a built-in condensate lift mechanism, adjustable
static pressure, multiple fan speeds, DRY Mode
and an operating sound as low as 23 dB(A) the
PEA system expands the number of installation
applications for the P-Series line.
PCA ceiling-suspended model
PKA wall-mounted model
PEA/PEAD horizontal ducted models
Auto Vane Control
With a simple press of the OFF button, the vane closes the air outlet for a
clean presentation when not in use. During operation, the vane can be ad-
justed with the remote controller to the perfect position to direct the airflow
horizontally in cooling mode or towards the floor in heating mode, keeping
room temperature even and comfortable.
Lightweight, Easy-to-install Indoor Unit
The smallest PKA unit measures about 36” wide, 11-1/2” tall and 9-3/4”
deep. It weighs just 29 lbs., is easily installed above windows or door-
ways, and can typically be installed by just two licensed installers in about
half of a day. And the PKA-Series models don’t even require ductwork,
only a small three-inch opening in the wall or ceiling, so they can be in-
stalled in some of the toughest spaces, even on brick and masonry walls.
Ultimate Comfort Meets
Ultimate Convenience
Select from a wall-mounted, hard-wired controller
(PKA-HA/KA) for ultimate comfort control.
The set-temperature display is large and easy to read.
Using the 24-hour timer, you can get the unit operation
to start and stop at specified times and to repeat daily.
And the convenient remote provides easy control of
the Fan Speed as well as the COOL, HEAT, AUTO and
DRY modes from anywhere in the room.
The hand-held wireless remote controller is easier to
use than most TV remotes for the PKA-HA(L)/KA(L).