Quick start manual

3 First Functional Test
The wir ing dia gram below (Fig. 3-1) shows the min i mum con nec tions that you must make to test
an MR-J3-T series ampli fier with the MR Configurator setup soft ware. In test mode you can
check whether all the com po nents are work ing prop erly.
NOTE You can also use the op tional MR-PRU-03 HMI con trol ter mi nal for per form ing ini tial tests
and set ting the am pli fier’s pa ram e ters. For fur ther de tails see the MR-J3-T se ries in struc tion
man ual.
3.1 Minimum Connections for the Functional Check
First Functional Test Minimum Connections for the Functional Check
MR-J3-T 3 - 5
Fig. 3-1: Wir ing di a gram for min i mum con fig u ra tion with out con trol ter mi nals
1-phase
200–230V AC
Servo motor
Motor