Quick start manual

Requi red for posi tio ning con trol via a CC-Link net work:

P Q-Rack with PLC and the CC-Link mo du le QJ61BT11N

A–Rack with PLC and CC-Link module A1SJ61BT11, A1SJ61QBT11 or FX2N-16CCL-M

P CC-Link ca ble com pa ti ble with ver sion V1.10 Stan dard

P Ca ble for con nec ting the PC/no te book to the PLC CPU:

Q se ries: SC-Q QC30R2

A and FX se ries: SC-09

P The GX IEC De vel oper pro gram ming soft wa re pa cka ge for con fi gu ra ti on of the data com -

mu ni ca tions set tings

NOTE This Quick Start Ma nu al des cri bes the in stal la ti on and se tup of a ty pi cal ser vo sys tem con -

si sting of an MR-J3-10T ser vo am pli fier (sing le-pha se, 230V / 100W) and an HF-KP13 ser -

vo mo tor. Note that the spe ci fi ca tions of this sam ple sys tem may dif fer from tho se of your

con fi gu ra ti on – plea se check your equipment’s instruction manuals for de tails if necessary.

Preparations Introduction

1 - 2 MITSUBISHI ELECTRIC