Instruction manual

12 - 11
12. OPTIONS AND AUXILIARY EQUIPMENT
(c) When fabricating the encoder cable
When fabricating the cable, prepare the following parts and tool, and fabricate it according to the wiring
diagram in (b). Refer to Section 12.8 for the specifications of the used cable.
Parts/Tool Description
Connector set MR-ECNM
For CN2 connector
Connector housing: 54593-1011
Cover A: 54594-1015
Cover B: 54595-1005
Shell cover: 58935-1000
Shell body: 58934-1000
Cable clamp: 58937-0000
Screw: 58203-0010
(Molex)
Junction connector
Housing: 1-172161-9
Connector pin: 170359-1
(Tyco Electronics or equivalent)
Cable clamp: MTI-0002
(Toa Electric Industries)
(3) MR-J3JCBL03M-A1-L MR-J3JCLB03M-A2-L
The servo amplifier and servo motor cannot be connected with these cables only. The servo motor side
encoder cable (MR-EKCBL
M-L/H) is required.
Cable Model
Cable
Length
Protective
Structure
Flex Life Application
MR-J3JCBL03M-A1-L For HF-MP HF-KP servo motor
Load side lead
Use in combination with MR-EKCBL
M-L/H.
MR-J3JCBL03M-A2-L
0.3m IP20 Standard
For HF-MP HF-KP servo motor
Opposite-to-load side lead
Use in combination with MR-EKCBL
M-L/H.