Instruction manual

1 - 5
1. FUNCTIONS AND CONFIGURATION
1.4 Function list
The following table lists the functions of this servo. For details of the functions, refer to the reference field.
Function Description
(Note)
Control mode
Reference
Position control mode This servo is used as position control servo. P
Section 3.2.1
Section 3.6.1
Section 4.2
Speed control mode This servo is used as speed control servo. S
Section 3.2.2
Section 3.6.2
Section 4.3
Torque control mode This servo is used as torque control servo. T
Section 3.2.3
Section 3.6.3
Section 4.4
Position/speed control change
mode
Using external input signal, control can be switched between
position control and speed control.
P/S Section 3.6.4
Speed/torque control change
mode
Using external input signal, control can be switched between
speed control and torque control.
S/T Section 3.6.5
Torque/position control change
mode
Using external input signal, control can be switched between
torque control and position control.
T/P Section 3.6.6
High-resolution encoder
High-resolution encoder of 262144 pulses/rev is used as a
servo motor encoder.
P, S, T
Absolute position detection
system
Merely setting a home position once makes home position
return unnecessary at every power-on.
P Chapter 15
Gain changing function
You can switch between gains during rotation and gains during
stop or use an external signal to change gains during
operation.
P, S Section 8.6
Advanced vibration
suppression control
This function suppresses vibration at the arm end or residual
vibration.
P Section 8.4
Adaptive filter
Servo amplifier detects mechanical resonance and sets filter
characteristics automatically to suppress mechanical vibration.
P, S, T Section 8.2
Low-pass filter
Suppresses high-frequency resonance which occurs as servo
system response is increased.
P, S, T Section 8.5
Machine analyzer function
Analyzes the frequency characteristic of the mechanical
system by simply connecting a servo configuration software-
installed personal computer and servo amplifier.
MR Configurator (servo configuration software) MRZJW3-
SETUP221E is necessary for this function.
P
Machine simulation
Can simulate machine motions on a personal computer screen
on the basis of the machine analyzer results.
MR Configurator (servo configuration software) MRZJW3-
SETUP221E is necessary for this function.
P
Gain search function
Personal computer changes gains automatically and searches
for overshoot-free gains in a short time.
MR Configurator (servo configuration software) MRZJW3-
SETUP221E is necessary for this function.
P
Slight vibration suppression
control
Suppresses vibration of 1 pulse produced at a servo motor
stop.
P Parameters No. PB24
Electronic gear Input pulses can be multiplied by 1/50 to 50. P
Parameters
No. PA06, PA07
Auto tuning
Automatically adjusts the gain to optimum value if load applied
to the servo motor shaft varies. Higher in performance than
MR-J2-Super series servo amplifier.
P, S Chapter 7
Position smoothing Speed can be increased smoothly in response to input pulse. P Parameter No. PB03
S-pattern acceleration/
deceleration time constant
Speed can be increased and decreased smoothly. S, T Parameter No. PC03
Regenerative brake option
Used when the built-in regenerative brake resistor of the servo
amplifier does not have sufficient regenerative capability for
the regenerative power generated.
P, S, T Section 12.2