Specifications
30
BCN-B11127-478*
Code No. Item
Writing data (RW
wn+3
) contents
(PLC
Servo amplifier)
8600
to
861F
Speed data of position block (RAM)
Writes the speed data Nos. of position block No. 00 to
31 to RAM. These values are cleared when power is
switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the position block No.
Convert the values into hexadecimal before making
setting.
8700
to
871F
Acceleration time constant of position block (RAM)
Writes the acceleration time constants of position
block No. 00 to 31 to RAM. These values are cleared
when power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the position block No.
Convert the values into hexadecimal before making
setting.
8800
to
881F
Deceleration time constant of position block (RAM)
Writes the deceleration time constants of position
block No. 00 to 31 to RAM. These values are cleared
when power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the position block No.
Convert the values into hexadecimal before making
setting.
8900
to
891F
Dwell time of position block (RAM)
Writes the dwell time constants of position block No.
00 to 31 to RAM. These values are cleared when
power is switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the position block No.
Convert the values into hexadecimal before making
setting.
8A00
to
8A1F
Advanced function of position block (RAM)
Writhes the advanced function of position block No. 00
to 31 to RAM. These values are cleared when power is
switched off.
The decimal value converted from the 2 lower digits of
the code No. corresponds to the position block No.
Convert the values into hexadecimal before making
setting.
8B00
to
8B1F
8C00
to
8C1F
Position data of position block (EEP-ROM)
Writes the position data of position block No. 00 to 31
to EEP-ROM. Written to EEP-ROM, these values are
held if power is switched off.
The lower 16 bits are written in even code and the
upper 16 bits in odd code.
Example
Instruction code 8B13:
Lower 16 bits of position block No. 19
Instruction code 8C13:
Upper 16 bits of position block No. 19
Convert the values into hexadecimal before making
setting.