Service manual

3. Detachment the Vegetable case parts Ph
oto 5
(1) Detach parts inside vegetable compartment (Vegetable case, Fruit case).
(2) Detach the door of vegetable compartment.
(3) Detach rivet (C) at the right and unhooking 2 catches at front,
(center and left). (Photo 5)
Caution on assembly
[1] Be sure to put vegetable case cover on the catches at the rear of
vegetable compartment.
Water pump motor
(4) Remove two screws and cut the lead wire of water-pump motor to
detach it.
4. Detach the refrigerator room parts Photo 6
(1) Detach parts inside the refrigerator compartment.
(2) Detach parts inside the vegetable compartment.
(3) Detach a left screw of mirror hinge and pull out the lead wire.
(Photo 7)
(4) Detach the connector.
Control panel , Duct R, Temperature control panel Photo 7
(5) Remove the upper and lower rivets (C) of right side and left side,
then unhook 7 catches.(9 catches for C405B)
* Remove the right catch before push the control panel to the right
and detach it. (Photo 7)
Fan grille
(6) Remove the following; Screw (A) at the upper and right center,
2 screws (B) at the left and 2 screws (B) at the right. (Photo 6)
* Motor damper and thermal fuse are combined with fan grille.
* Fan and fan motor are combined with fan grille.
Caution on assembly
[1] Use new tapes and sealing materials for assembly.
[2] Putting some tape across joints, tape them securely so that they will
not leak the cool air.
[3] Attach a connector securely in order to prevent contact failure.
OPERATING PROCEDURE PHOTOS
Rivet
Catches
Catch
Catch
Vegetable
ca
se cover
V-room
Screw
Fan grille
F-room
Screw
Catch
CatchCatch
Catch
Catch
Catch
Screw
Lamp
Rivet
Control panel
Rivet
Rivet
Rivet
Mirror hinge
R-room
Catch
Catch
Catch
(only:C405B)
(only:C405B)
20