User`s manual

4 - 12
4 INSTALLATION AND WIRING
POINTS
(8) Put the SSCNET cable in the duct or fix the cable at the closest part to the
Motion CPU module with bundle material in order to prevent SSCNET
cable
from putting its own weight on SSCNET
connector.
When laying cable, the optical cord should be given loose slack to avoid from
becoming smaller than the minimum bend radius, and it should not be twisted.
Also, fix and hold it in position with using cushioning such as sponge or rubber
which does not contain plasticizing material.
(9) If the adhesion of solvent and oil to the code part of SSCNET
cable may
lower the optical characteristic and machine characteristic. If it is used such an
environment, be sure to do the protection measures to the cord part.
(10) When keeping the Motion CPU or servo amplifier, be sure to put on a cap to
connector part so that a dirt should not adhere to the end of SSCNET
connector.
(11) SSCNET
connector is put a cap to protect light device inside connector from
dust. For this reason, do not remove a cap until just before connecting
SSCNET
cable. Then, when removing SSCNET cable, make sure to put a
cap.
(12) Be sure to keep a cap and the tube for protecting light code end of SSCNET
cable in a plastic bag with a zipper of SSCNET
cable to prevent them from
becoming dirty.
(13) When exchanging the servo amplifier or Motion controller, make sure to put a
cap on SSCNET
connector. When asking repair of servo amplifier or Motion
controller for some troubles, make also sure to put a cap on SSCNET
connector. When the connector is not put a cap, the light device may be
damaged at the transit. In this case, exchange and repair of light device is
required.