User`s manual

4 - 8
4 INSTALLATION AND WIRING
(b) Removal from Q3
DB and Q6 B
Push
Module fixing hook
Completion
Support the module with both
hands and securely press the
module fixing hook with your
finger.
Pull the module based on the
supporting point of module
bottom while pressing the
module fixing hook.
While lifting a module, take off
the module fixing projection
from the module fixing hole.
When using the module fixing
screws, remove them.
Lifting
Module
Base unit
Module
connector
Module fixing hole
Pull
POINT
When the module fixing screw is used, always remove the module by removing the
module fixing screw and then taking the module fixing latch off the module fixing
hole of the base unit.
Attempting to remove the module by force may damage the module fixing latch.
CAUTION
Do not touch the heat radiating fins of controller or servo amplifier's, regenerative resistor and
servomotor, etc. while the power is ON and for a short time after the power is turned OFF. In
this timing, these parts become very hot and may lead to burns.
Remove the modules while paying attention.