User`s manual

4 - 6
4 INSTALLATION AND WIRING
4.1.3 Installation and removal of module
This section explains how to install and remove a power supply module, PLC CPU
module, Motion CPU module, Motion module, I/O module, intelligent function module
or another module to and from the base unit.
(1) Installation and removal of the module from Q3 DB,Q6 B
(a) Installation of the module on Q3 B and Q6 B
Make sure that the module is
installed in the base unit
securely.
Securely insert the module
fixing protection into the
module fixing hole so that the
latch is not misaligned.
Using the module fixing hole
as a fulcrum, push the module
in the direction of arrow to
install it into the base unit.
END
(Note)
When using module in a place
where there is large vibration
or impact, install them by the
unit fixing screws.
Base unit
Module
connector
Module fixing hole
Module
Module
fixing hook
Module
fixing hook
Module fixing hole
Module
loading
lever
Base unit
Unit fixing
projection
Base unit
Module fixing hole
Base unit
Module fixing hole
Module
fixing hook
Module loading
lever
Module
fixing hook
(Note): Screw the Motion CPU module to the main base unit.