Specifications

Additional procedures Project creation
Motion controller Q170MCPU/ Q172DCPU/ Q173DCPU 5 - 13
5.2.3 Writing project to the Motion/PLC CPU
This section explains the method for writing a project saved in the hard disk or other memory media
of the personal computer to the Motion/PLC controller internal memory.
Operating Procedure (MT Developer2)
 Select "Online" - "Write to CPU". The "Write to CPU" screen appears.
 Once download is complete, another message will appear asking if you would like to place the
controller back in Run mode. Again, select Yes and then Close.
 The specified data is written to the target memory. When writing is completed, the dialog box
appears notifying the process completion.
 Select Program memory as target memory
to write to.
 Click on Parameter+ Program to select the
data to be written.
 Click the Execute button.
When a password is registered, the Pass-
word Check dialog box appears.
When program write is to be executed, a
message appears if there are programs that
have not been converted.
 The screen on the left appears if the motion
controller is in RUN mode.
Click the OK button.