Specifications

Additional procedures Project creation
Motion controller Q170MCPU/ Q172DCPU/ Q173DCPU 5 - 11
5.2 Additional procedures
5.2.1 Transfer setup
This section explains how to set the communication between PC and Q170MCPU/Q172DCPU by the
Transfer Setup screen.
For the sake of simplicity, it will be explained how to configure the communication by using a direct
connection with an USB cable.
Operating Procedure (Motion CPU access)
Double-click on Serial/USB button in the "PC side I/F" selection.
Select USB and close the pop-up window.
Select PLC module in the "CPU side I/F".
Select No specification in the "Other Station" setting.
Select PLC No.2 as "Target System".
Operating Procedure (PLC CPU access)
Double-click on Serial/USB button in the "PC side I/F" selection.
Select USB and close the pop-up window.
Select PLC module in the "CPU side I/F".
Select No specification in the "Other Station" setting.
Select PLC No.1 as "Target System".